1. The shaft bears the full load of the negative machine, so good lubrication has a great relationship with the bearing life. It directly affects the service life and operation rate of the machine. Therefore, the required oil must be cleaned and the seal must be good. Main oil filling: rotating bearings, roller bearings, all gears, moving bearings, sliding plane. 2. The newly installed tires are prone to loosening and must be inspected frequently. 3, pay attention to whether the work of all parts of the machine is normal 4, pay attention to check the wear level of the wear parts, and always pay attention to replace the worn parts. 5. Place the bottom plane of the movable device, and the dust should be removed to prevent the movable bearing from moving on the chassis when the machine encounters materials that cannot be broken, resulting in serious accidents. 6, the bearing oil temperature rises, should stop immediately to check the reasons to eliminate. 7. If there is impact sound when the rotating gear is running, it should be stopped and checked immediately and eliminated. BesidesTerex,Allison Transmission,Cummins Parts,we can also provide other machinery equipment parts,Caterpillar 777,789;Sany mining machine STR95,STR55,Shougang Heavy Duty Truck SGA3722 series spare products;Fleetguard filter;Rexroth pump;ESCO bucket teeth etc. Hyundai Spare Parts,Mobile Spare Parts,Cheap Spare Part,Spare Parts Chengdu Svoda Machinery Equipment Co.,Ltd , https://www.svdequip.com
If you need above mention machinery equipment Spare Parts,please feel free contact us.
If the magnetic separator motor is overheated, if the motor of the magnetic separator is overheated, it will be accompanied by abnormal sound. We must know that this situation occurs, it is likely that the bearing oil of the magnetic separator is not enough. Or the bearing of the magnetic separator is too worn, and secondly it may be caused by poor contact of the magnetic separator. At the same time, the voltage of the magnetic separator may be insufficient. Then, if the magnetic separator of the magnetic separator is overheated, It may be that the magnetic separator has insufficient oil or poor oil quality, which may cause the magnetic separator to wear and the bearing to be poorly lubricated.