(1) no water or no water, mostly due to the end of the valve stuck, partial blockage of the water filter; absorbent height is too high or suction pipe leaks; and impeller tract infarction induced, should be identified to take the appropriate method of treatment. Tips: Installation and troubleshooting of agricultural pumps (2) pipe leakage or leakage, the device can be tightened bolt. If the leakage is not serious, in the center of leaking or leaking paint grout, and tighten the nut with a wrench; if serious water leakage, we must reload. (3) water pump violent vibration, can be uneven in the electric rotor, shaft coupling may be bad, bearing wear and bending; can also be caused by rotating parts slack, rupture and pipe support is not strong and so on. Should be adjusted depending on the situation to stop, strengthen, straighten or change. More Search Keywords: water pump industry Hose Pump beed used to transfer concrete, sewage, sludge, excrement, etc. it's have vertical and horizontal type. Unique without sealing structure make it won't create any leaks. Strong self-priming capacity, water absorption can reach 8 meters. The pump suction fluid contact with rubber hose, only thus can transport all kinds of viscosity, density, corrosion resistance, abrasive fluid material. Can deliver a solid particles, crystals, fiber material and other impurity liquid materials, won't produce any blockage and fault. Industrial Hose Pump,Industrial Hose Peristaltic Pump,High Pressure Hose Pump,Industrial Peristaltic Pump Botou Honghai Pump Co.,Ltd , https://www.gearpump.nl